Heco Roof Support W/O Sleeve

1. Raise the roof to the upright position and block or support it so it cannot fall.
2. Remove the 3/8" × 3" center pivot bolts from the rear and front roof supports.
3. Remove the small set screw at the top of both roof supports.
4. Have a second person pull the rear roof support toward the trailer center while removing the lower bolt on the front roof support (this relieves tension).
5. Slide the front and rear roof supports downward to disengage them from the torsion-bar legs.
6. Remove the front bolt on the torsion-bar pivot to drop the assembly, then slide it forward to disengage from the rear anchor; replace parts as needed.
7. Reassembly alignment: align the hexes on the rear anchor — the torsion-bar legs must point toward the outside of the camper, not the middle.
8. Reverse the procedure to reassemble.

Full guide with diagrams, maintenance tips, and troubleshooting: HECO/Harmony Lift System Guide.