Lift System Parts
Viking/Coachmen Lift Arm – 4 Stage
SKU: PA-VIKI2515530
$144.90
Part details
4-Stage Telescoping Lift Arm for Viking/Coachmen L&W Systems
This is a complete replacement 4-stage telescoping corner lift arm for Viking and Coachmen pop-up campers equipped with the L&W lift system. The L&W repair manual confirms that 4-stage units are a standard component of this system. If your original corner lift arm is severely bent, rusted, or structurally compromised, this is the direct replacement assembly you need to restore the safety and function of your camper's roof.
Is This The Correct Lift Arm For You?
To verify that you have a 4-stage lift arm, please use the following method:
- Raise your camper roof to its full height.
- Count the number of movable, visible telescoping sections on one of the corner posts.
- If you see three visible sections, you have a 4-stage lift arm (3 visible sections + 1 base section = 4 stages).
Product Details:
- Type: 4-Stage Telescoping Lift Arm.
- Compatibility: For Viking and Coachmen campers using the L&W lift system.
- Function: Replaces a damaged corner post to ensure the roof is properly and safely supported.
- Sold Individually.
Installation Note: The L&W repair manual provides detailed, step-by-step instructions for replacing the telescoping lift arms. The process involves bracing the roof and changing only one arm at a time for safety.
Installation: Replacing L&W Telescoping Lift Arms / Posts
Safety: Prop the roof with solid supports before servicing. After any repair, raise and lower the roof several times and confirm the door seats properly.
- Raise the roof and securely brace all four corners, bracing between the end-wall cap and the roof “H” rail.
- Remove the tent from the curtain track at the top of the roof side.
- Remove the lift arm cover and the screws from the sidewall cap; lift the cap up. Do not untuck the tent.
- Remove the top arm bolt. CAUTION: only replace one arm at a time.
- Crank the winch all the way down.
- Remove the old arm by lifting it out of the sidewall pocket.
- Install the new arm, ensuring the screw in the bottom of the arm faces the inside of the camper.
- Reverse the previous steps to reassemble, then adjust the final roof height (targets are in the guide).
Full guide with diagrams, maintenance tips, and troubleshooting: L&W Lift System Guide.
Listed fitments (1)
Check your model, lift system and cable position against these listings and the part details.