Lift System Parts
Jayco Lift Post 3-Stage 28.00 Clear Dichromate
SKU: PA-JAYC0193263
$367.50
Part details
Jayco 3-Stage Telescoping Lift Post, Clear Dichromate (0189247)
This is a complete replacement 4-stage telescoping corner lift post for Jayco pop-up campers equipped with the L&W lift system. The L&W repair manual confirms that 4-stage units are a standard component of this system. If your original corner post is severely bent, rusted, or structurally compromised, this is the direct replacement assembly you need to restore the safety and function of your camper's roof.
Is This The Correct Post For You?
To verify that you have a 3-stage post, please use the following method:
- Raise your camper roof to its full height.
- Count the number of movable, visible telescoping sections on one of the corner posts.
- If you see three visible sections, you have a 3-stage post (2 visible sections + 1 base section = 4 stages).
System Note:
The repair manual for the L&W system indicates that there are different roof height specifications for "earlier" and "later" 4-stage units. When ordering, it is important to provide your camper's year and model to ensure you receive the correct post.
Product Details:
- Type: 3-Stage Telescoping Lift Post.
- Jayco Part Number: 0189247
- Finish: Clear Dichromate
- Compatibility: For Jayco campers using the L&W lift system.
- Function: Replaces a damaged corner post to ensure the roof is properly and safely supported.
- Sold Individually: The price listed is for one corner post.
Installation: Replacing L&W Telescoping Lift Arms / Posts
Safety: Prop the roof with solid supports before servicing. After any repair, raise and lower the roof several times and confirm the door seats properly.
- Raise the roof and securely brace all four corners, bracing between the end-wall cap and the roof “H” rail.
- Remove the tent from the curtain track at the top of the roof side.
- Remove the lift arm cover and the screws from the sidewall cap; lift the cap up. Do not untuck the tent.
- Remove the top arm bolt. CAUTION: only replace one arm at a time.
- Crank the winch all the way down.
- Remove the old arm by lifting it out of the sidewall pocket.
- Install the new arm, ensuring the screw in the bottom of the arm faces the inside of the camper.
- Reverse the previous steps to reassemble, then adjust the final roof height (targets are in the guide).
Full guide with diagrams, maintenance tips, and troubleshooting: L&W Lift System Guide.
Listed fitments (1)
Check your model, lift system and cable position against these listings and the part details.