Lift System Parts
Starcraft LIFTER CABLE-RT. REAR 177-1/4″ OVERALL HYDR. LIFT UNIT
SKU: PA-STAR3305-5069
$18.90
Part details
Right Rear Lifter Cable for Starcraft Hydraulic Lift (177 1/4" / Part No. 3305-5069)
This is a 177 1/4-inch replacement Right Rear Lifter Cable for Starcraft pop-up campers equipped with the optional Hydraulic Lift System. This is a direct replacement for the original cable to ensure proper fit and function.
IMPORTANT: For Hydraulic Lifts Only
This cable is specifically for Starcraft models that have the Hydraulic Lift Option. It will not work on standard manual crank winch systems.
Important Shipping Information
Please allow up to 1 week for this cable to ship.
Product Specifications & Compatibility:
- Part Number: 3305-5069
- Location: Right Rear Lifter Cable
- Overall Length: 177 1/4 Inches
- System: For Hydraulic Lift Units
Compatibility Guide
According to the provided parts chart, this cable (3305-5069) fits the Right Rear position on the following models when equipped with the hydraulic lift option:
- 1996: GALAXIES, STARMASTER, STARLOUNGE, SATELLITE
- 1997: Models with Hydraulic Lift Option
- 1998: Models with Hydraulic Lift Option
Installation: Replacing a Winch Cable (1983–2000 System)
Safety: Release the dolly-wheel jack clamp and lower the camper front to gain clearance at the back before starting.
- Era check: this procedure is for the 1983–2000 system — a winch with FOUR cables and turnbuckles. If your Starcraft has a tongue-mounted winch with ONE cable to a 4-way yoke, use the 1982-and-older guide instead.
- Backwind the winch until all tension is removed and no cable is wrapped on the drum.
- Loosen the drive-shaft retaining collar set screw and slide the shaft left until it clears the main-beam bushing (file off any burr).
- Remove the two rear winch-plate bolts to drop the plate for access (remove the front bolts too if needed).
- Remove the set screw holding the ball end of the old cable in the drum; disconnect the turnbuckle and eyebolt without twisting the cables; thread the old cable out.
- Thread the new cable in place and fasten the ball end in the drum with the allen set screw — use 242 Loc-Tite and leave 1/16" of thread showing outside the drum.
- Refasten the winch plate (torque the four bolts to 11 ft/lbs); slide the shaft over until the gears mesh, leaving 1/32" of end play; lock the retaining collar.
- Screw the eyebolt into the turnbuckle until 2–3 threads show on the inside. Do not twist or cross the cables. Do not tighten the jamb nut yet.
- Adjust the roof height following the Winch section of the guide, then tighten the jamb nuts.
Full guide with diagrams, maintenance tips, and troubleshooting: Starcraft 1985–2000 Guide.
Listed fitments (7)
Check your model, lift system and cable position against these listings and the part details.