2-stage
1 moving section
+ 1 base = 2 stages
PopupCamperGuy parts
Inner-Arm Lifter Cables
Select a part category or model series below.
See the lift parts inside the camper
L&W repair guideThe post sits in the camper's corner wall pocket. The floor track and curved guide carry the push spring up inside it to lift the roof.
- 1Telescoping lift post
Nested metal sections extend from the wall pocket to the roof attachment.
- 2Post inside the wall
The lower section is concealed below the sidewall cap, inside the camper body.
- 3Curved corner guide
Turns the flexible push spring upward from the floor into the post.
- 4Drive slug
An elongated, slotted metal driver inside the straight floor track. The cable pulls it against the push spring.
- 5Push spring & floor track
The long coil runs along the track and up the post. The thin orange line marks the lift cable.
ACTUAL REPLACEMENT PART
Drive slug: check the long, slotted profile
This is the supplier photograph of the 7/8-inch Jayco slug, part 0087212. The 3/4-inch version is a separate part, 0012372. Match the original part and track size.
View the 7/8-inch drive slug →Recognize your lift post
Count every telescoping section, including the outer base.
3-stage
2 moving sections
+ 1 base = 3 stages
4-stage
3 moving sections
+ 1 base = 4 stages
Stage count identifies the type. Post length, mounting points, and camper details must also match. Do not raise a damaged lift system just to count sections.
References: L&W service instructions and 7/8-inch slug record. 2-stage reference: A-44 / 0012390.
1 part
