Lift System Parts
Jayco Pulley, Wall W/ 2 Pulleys & Bracket
SKU: PA-JAYC0150468
$33.60
Part details
Wall-Mounted Double Pulley & Bracket for Jayco L&W Systems
This is the replacement wall-mounted double pulley assembly for Jayco pop-up campers using the L&W lift system. This bracket is mounted vertically on the camper's interior wall to route two 3/32" lift cables, typically from the floor tracks up towards the roof. Both the L&W repair manual and the 1998 Eagle Lifter System diagram confirm the use of wall-mounted pulley brackets in this system.
A worn-out or seized pulley can cause grinding noises, create excessive drag in the system, and will quickly fray and destroy the lift cables. Replacing a faulty pulley assembly is critical to protecting your cables and ensuring the lift system is easy to operate.
Product Details:
- Jayco Part Number: 0150468
- Function: Guides two 3/32" lift cables vertically up the camper wall.
- Mounting: Attaches to the interior sidewall of the camper.
- Pulleys: Includes two pre-installed pulleys.
- Compatibility: For Jayco campers using the L&W lift system.
- Sold as a complete assembly.
Installation Note: The L&W repair manual provides instructions for replacing the "Double Pulley with Bracket". On original brackets, a pin weld may need to be drilled or broken for removal. The replacement bracket is designed to be secured with a bolt.
Installation: Replacing an L&W Pulley / Pulley Bracket
Safety: Prop the roof with solid supports before servicing. After any repair, raise and lower the roof several times and confirm the door seats properly.
- Raise the roof and brace it securely.
- Crank the winch down 4–5 turns.
- Remove the bolts from the pulley track (pulley brackets are on the sidewall and floor in the opposite corner from the winch).
- Break the pin weld on the bracket and pry it apart: drill through the bracket from the backside to remove the weld area, or split the two metal pieces with a chisel.
- Remove the cables from the pulley, noting whether they ride on the top or bottom side of the pulley.
- Break the pin weld on the new bracket (drill from the backside) and place the cables back in the same position.
- The new bracket does not need to be welded; a bolt will hold it once it is back in place.
- Reverse the previous steps. Make sure the cables do not rub on the wheel well, then adjust the final roof height.
Full guide with diagrams, maintenance tips, and troubleshooting: L&W Lift System Guide.
Listed fitments (1)
Check your model, lift system and cable position against these listings and the part details.