Lift System Parts
Viking/Coachmen Lift Cables – Set Of 4
SKU: PA-VIKI2510100
$63.00
Part details
Custom-Made Lift Cable Set for Viking/Coachmen Campers (Set of 4)
This is a complete, custom-made set of all four replacement lift cables for your Viking/Coachmen pop-up camper's L&W lift system. These cables are manufactured to the precise specifications of your trailer to ensure a perfect fit and proper operation. This is a special-order item; please read the ordering instructions carefully.
Important Lead Time & Policy
- Custom-Made Item: As this cable set is made to your specific camper's dimensions, it is non-returnable and non-refundable. Please ensure your information is accurate.
- Manufacturing Lead Time: Please allow up to 1 week for your custom cable set to be manufactured before it ships.
HOW TO ORDER: Required Camper Information
To ensure your new cables are the correct length, you must provide the following information using the required fields on this page:
- Year of your Viking/Coachmen camper
- Make (Viking/Coachmen)
- Model of your camper
IMPORTANT: You must provide the specific model name or number (e.g., "12SO", "14SO"). "Clipper" is a series, not a model, and is not specific enough for ordering. Missing or incorrect model information will delay your order.
Product Details:
This product contains a full set of four (4) corner lift cables. This corresponds to the 3/32" lift cables in the L&W lift system. Each cable is cut and finished to the exact length required for the camper model you provide.
Installation: Replacing a 3/32" Corner Lift Cable
Safety: Prop the roof with solid supports before servicing. After any repair, raise and lower the roof several times and confirm the door seats properly.
- Raise the roof and brace it securely.
- Create slack and remove the corresponding eyebolt nut from the harness square.
- Remove interior panels or covers needed to access the cable route.
- Remove the lift arm and the pusher spring (procedures in the guide).
- Carefully pull the old cable through all pulleys, noting its exact route for reinstallation.
- Remove the drive slug from the end of the old cable.
- Feed the new cable back through the pulleys, starting from the winch area.
- Re-attach the drive slug: the wide slot goes in the corner with the track pulley; if the track has no pulley, turn the wide slot toward the lower front corner of the spring track.
- Reassemble the spring, arm, and covers, then adjust the final roof height.
Full guide with diagrams, maintenance tips, and troubleshooting: L&W Lift System Guide.
Listed fitments (1)
Check your model, lift system and cable position against these listings and the part details.