Lift System Parts
Viking/Coachmen Main Cable (L&W)
SKU: PA-VIKI668571
$44.84
Part details
Custom-Made Main Cable with Harness Block for Jayco L&W Systems
This is the complete, custom-made main pull cable assembly for Coachmen/Viking pop-up campers with the L&W lift system. This is the heavy-duty 3/16-inch cable that connects the winch to the 2x2 harness block (also called the harness square), doing all the primary pulling for the roof lift. This is a special-order item; please read the ordering instructions carefully.
Important Lead Time & Policy
- Custom-Made Item: As this cable is made to your specific camper's dimensions, it is non-returnable and non-refundable. Please ensure your information is accurate.
- Manufacturing Lead Time: Please allow up to 1 week for your custom cable assembly to be manufactured before it ships.
HOW TO ORDER: Required Camper Information
To ensure your new cable is the correct length, you must provide the following information using the required fields on this page:
- Year of your Coachmen/Viking camper
- Make ( Coachmen/Viking)
- Model of your camper
IMPORTANT: You must provide the specific model name or number (e.g., "12SO", "14SO"). "Clipper" is a series, not a model, and is not specific enough for ordering. Missing or incorrect model information will delay your order.
Product Details:
This product is a complete main cable assembly that includes:
- One (1) 3/16" main lift cable cut to the proper length.
- The 2x2 steel harness block (harness square) pre-installed.
- The necessary needle bearing and flat washers between the cable crimp and the block.
Installation: Replacing the 3/16" Main Cable
Safety: Prop the roof with solid supports before servicing. After any repair, raise and lower the roof several times and confirm the door seats properly.
- Raise the roof and brace it securely; remove the winch cover.
- Crank the winch down 4–5 turns to create slack.
- Remove the cable keeper nut and bolt from the side of the winch spool and unwrap the old cable.
- Pull the cable back through the harness square (2"×2" steel block) to remove it.
- Thread the new cable through the harness square, ensuring the needle bearing and washers are in place between the crimp and the block.
- Thread the cable through the winch spool and reattach with the cable keeper.
- Crank the winch to the up position while holding tension on the cable. Ensure at least two wraps of cable remain on the spool when the roof is fully down.
- Reassemble and adjust the final roof height.
Full guide with diagrams, maintenance tips, and troubleshooting: L&W Lift System Guide.
Listed fitments (1)
Check your model, lift system and cable position against these listings and the part details.